COMPUTER REPAIR | FROM NEW COMPUTER ACCESSORIES

If the PC often show the existence of lawyer-complex, or display an error message, sounds beep continuously with regularly or irregularly, the PC is most likely being in trouble, I will provide tips and solutions to overcome these problems and the PC You can serve again as usual. Problems or damage arising typically categorized in two types of damage are: problem or damage to Hardware and Software

Damage Type Can be categorized into two categories, namely:
1. Damage to the Hardware (Hardware)
2. Damage In Software (Software)

1. Damage to the Hardware
Problems with hardware components need to be serious because of difficult handling localized and removed without the proper tools, skills and experience that support. The explanation will revolve around the problems that often occur along with how to cope.
Damage to the Power Supply
Symptoms:
When turned on the PC does not react to anything, no display on the monitor, there is no indicator light (LED) is lit, power supply fan is not spinning, the indicator light on the monitor is not lit.
Solution:
Check whether the cable is properly connected and installed properly plug into the socket, also check that there is the on / off behind exactly behind the Power Supply is in the On position, If you are sure is installed correctly but still no response to assure you please replace the power cord with you believe fine. The problem occurs because of the absence of incoming voltage, there is damage to the power cable.
Problem:
When turned on the PC does not react to anything, no display on the monitor, there is no indicator light (LED) is lit, power supply fan is not spinning, the indicator light on the monitor turns on.
Solution:
Do as above steps, but if there was still no response means problem in Power Supply, PS Please change it, I suggest you should just replace the damaged Power Supply with a new one, and be careful in the installation.
Note: If the damage is only on the Power Supply alone, When you replace it, the computer will return to work normally. Unless there is a problem in other components such as the Mother Board, VGA Card and Memory.

Damage in Mother Boards
Symptoms:
When turned on, no display on the monitor, indicator light (LED) on the front panel is lit, the indicator light (LED) flashing monitors, power supply fan and processor fan spins, no beep sound on the speakers.
Solution:
The first step off all power cables connected to the electrical, data cable to the monitor, wired keyboard / mouse, and all cables are connected to the CPU, then cashing out all the screw covers. In an open case please also remove other components, namely the voltage from the power supply cable connected to the motherboard, hard drive, floppy, be careful in the process do not rush. Likewise with the card attached to the Motherboard (VGA, Sound or Other Card). Now attached to the motherboard just cashing it. Please check carefully Motherboad, see Chip (IC), Elko, transistor and others if there is a fire.
If there are no signs of burnt components likely motherboard is still good, but there are times when Mother board does not work because of damage to the program contained in the BIOS
Symptoms:
The CPU time started and then did post after that process does not continue and was silent for a moment did not directly go to the operating system, and then the screen is the message 'disk error, disk Failur, after it appeared the message "press F1 to continou" after we pressing the F1 key does not enter operating system and the message "Operating system not found".

Damage to the Hard Drive
Solution:
Check the tension cables and data cables into the hard drive is loose, should be tightened, then turn and let you listen to what came out of a normal hard disk, if not normal means damaged hard drive controller.
Symptoms:
The CPU time started and then did post after it appeared the message "Operating system not found".
Solution:
There is a possibility Operating system corrupted, can be overcome by installing  or if the OS you are using Windows 2000/XP there Repair facilities. or possibly a hard drive is not detected and you do the above steps
Symptoms:
hard disk bad sector?
Solution:
There are several factors that cause bad sectors such occurs, the voltage is unstable, often decided in a sudden flow of electricity, after using not shot down, consumption is too long, there are two types of bad sector physical and software ... .. To overcome some ways, including using software to eliminate badsector ....  further eBook is in computer repair methods and what you get if you join the Active Member.

Damage CD / DVD / ROM / RW & Floppy Disk
Symptoms:
This type of damage is commonly encountered:
1. Not detected in windows
2. Can not get out a CD
3. Can not read / write / can only read it. (CD)
4. Can not read / write / write protect (Floppy disk)
Solution:
1. Check the data cable and voltage cable into the CD-floppy, check the bios setup if it is detected? should be set to auto. Check if the led is lit, if not damage the controller.
2. Mechanical damage on the rubber motor or motors.
3. Usually the optical damage, but there may still be improved in a way to set the optical.
4. Gross Head, can be cleaned using  (above steps are complete can be found in e-book "method of computer repair fast and accurate